Mounting & Power
These sensors are ceiling mounted using industrial strength adhesive tape to the rear of the sensor's mounting bracket.
If ceiling level power via Mains or Power-over-Ethernet (PoE) isn't already available for the where the sensor will be installed into, we would require that an electrician or technician makes provision for power above the ceiling panel within 1m of the sensor's intended location.
These sensors are preconfigured with the SSID and Password to auto join their WiFi network by our team before installation.
Usually, we will preconfigure a dedicated 802.11b WiFi network for these sensors to operate on that we will manage remotely as these sensors require WiFi connectivity to reach our servers.
If you intend on using your corporate WiFi network for connecting these sensors, it is important to note that these sensors will cannot interact with a Captive Web Portal (CWP), landing page or any web-based authentication upon joining the network. As such, WPA2-Enterprise networks are not supported.